Compressed Air & Shop Equipment
Match the air system to simultaneous tool demand and the air quality those tools require. Compare delivered flow at working pressure, available storage and treatment equipment.
Compressed Air & Shop Equipment at a glance: Write down the tools that run together on a busy shift, their required pressure and their duty cycles. Use that demand profile to compare the compressor, dryer and receiver as a system.
- Equipment types
- 3
- Equipment types at a glance
- View comparison
- Buyer questions
- 7 answered
Side-by-side
Equipment types at a glance
| Equipment | When to consider it |
|---|---|
| Air Compressors | Compare delivered airflow at the pressure your equipment uses. Intermittent impact tools and a continuously running process place very different demands on the same compressor. |
| Compressed Air Dryers | Match a dryer to inlet conditions, system flow and the moisture level acceptable at the point of use. Compare rated capacity after adjustments for the planned operating conditions. |
| Air Receiver Tanks | A receiver provides storage for fluctuations in demand. Select the vessel and fittings for the system pressure, available footprint and service access specified for the installation. |
Buying guide
Compressed Air & Shop Equipment: what to know before you buy
Match the air system to simultaneous tool demand and the air quality those tools require. Compare delivered flow at working pressure, available storage and treatment equipment.
How to choose
- Map demand from room to tool. Compare supply pressure and required air quality at the point of use. Note long runs, multiple users and short demand peaks. Ask the supplier to separate generation, treatment, storage and distribution losses in the proposal.
- Map demand at the tool. Record which processes run together, the flow each consumes and the required pressure where it is used. Long pipe runs, treatment stages and peak draws can change the delivered air at the far end.
- Budget for treatment and service. Include filters, drains, dryer servicing and access around components. Compare system performance and operating expense at the intended pressure and plant conditions.
- Build a demand log for the busiest hour. List the tools that run together, their pressure requirements and how long they draw air. Ask for delivered flow at that pressure and compare duty ratings for the proposed work pattern.
- Check the rating conditions. Send the supplier your warmest inlet air, ambient temperature, operating pressure and expected flow. Ask for corrected capacity at those conditions and pressure drop through the proposed treatment package.
- Check the drawing against the room. Measure clear height along the delivery route as well as at the final location. On the dimensional drawing, locate the drain, inspection points and connecting pipework before choosing an orientation.
FAQ
Compressed Air & Shop Equipment questions
Is horsepower enough for comparison?
Use delivered flow and rated pressure alongside motor power. Check the rating conditions and duty cycle so the figures describe equivalent operation.
Refrigerated or desiccant?
Compare the pressure dew point each system is designed to deliver against process requirements. Include purge consumption or electrical demand in the comparison.
Vertical or horizontal?
Vertical vessels conserve floor area but need headroom. Horizontal vessels may fit lower spaces. Compare fittings, drain access and the route into the building.
Which site observations make quotes comparable?
Log pressure and demand during a normal shift and a peak shift. Share the readings, room conditions and service schedule with each supplier.
Why ask for service clearances before ordering?
Filters, belts or coolers may need more room than the cabinet footprint suggests. Request the maintenance drawing before positioning the machine against a wall.
Do filters come with the dryer?
Ask which inlet and outlet filters the manufacturer specifies, whether drains are included and what a full set of replacement elements costs.
What does receiver volume tell me?
It describes stored volume. Ask the system supplier to relate that volume to the allowed pressure swing and duration of your peak demand.